Barcus-berry 1460-N12 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Instrumentos Musicais Barcus-berry 1460-N12. Barcus Berry 1460-N12 User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 15
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
~1460, 1460-N12~
Acoustic Thinline
Transducers
Vista de página 0
1 2 3 4 5 6 ... 14 15

Resumo do Conteúdo

Página 1 - Transducers

~1460, 1460-N12~Acoustic ThinlineTransducers

Página 2

down with a non-marring tool (e.g. a plastic screwdriver handle) to makesure it is well seated. Re-string guitar.NOTE: Before evaluating the amplified

Página 4

BARCUS BERRY FAS-JAC ENDPIN JACK INSTALLATION:TOOLS RECOMMENDED FOR FAS-JAC INSTALLATION• One 16” to 18” (40cm-46cm) length of 1/4”(6.4mm) diameterrod

Página 5

the Fas-Jac through the end block until it is stopped by the nutthreaded onto the body of the Fas-Jac.6) Measure the length of the exposed Fas-Jac thr

Página 6

finger tight.8) Remove the rod from the Fas-Jac9) Place a 1/2” open end wrench or adjustable crescent wrenchover the end cap and tighten the cap while

Página 7

Limited WarrantyThis Barcus-Berry product is warranted for a period of one (1) year from the date of purchaseagainst defects in workmanship and parts.

Página 8

THANK YOU FOR YOUR PURCHASE OF A NEW BARCUS-BERRY 1460 ACOUSTIC THINLINE TRANSDUCERAt Barcus Berry, we value your trust in us to provide your guitarwi

Página 9

BEFORE INSTALLATIONThe Barcus Berry 1460 is designed for acoustic guitars thathave standard 2 1/8” bridge pin hole spacing, which is themeasurement be

Página 10

BARCUS BERRY 1460 INSTALLATION INSTRUCTIONSThe 1460 transducer has been engineered and manufactured toexacting tolerances, and designed from the begin

Página 11

TOOLS NECESSARY FOR INSTALLATION OF 1460 TRANS-DUCER• Variable speed electric drill• 3/32” drill bit• 15/32”(11.9mm) drill bit• Tapered reamer with 1/

Página 12

INSTALLATION INSTRUCTIONS:1) Use a sharp pencil to make temporary positioning marks on the bridgeat the high and low E locations. Remove strings and b

Página 13

drill the hole 17/64” (6.7mm) fromthe midpoint between the two highE strings to the nearest end of thesaddle slot. Be careful to locatethis hole accur

Página 14

4) Use variable speed drill with 15/32”(11.9mm) to drill through enlargedend pin hole.5) Remove all wood debris from saddle slot, then feed transducer

Página 15 - Limited Warranty

Remove approximately 1/4”(7mm) or the plastic shield, allowing enoughbare wire to solder it to the jack.8) Solder center wire to one of the short term

Modelos relacionados 1460

Comentários a estes Manuais

Sem comentários